In the walt settings you can add your WiFi Credentials, add Cellular Settings and adjust General Settings
Click on walt™ Settings in the Navigation Column
When you click into this setting, you will see 3 different tabs at the top of your screen (As shown below):
To set your wifi:
1. Make sure the WiFi Credentials tab is selected.
2. Click in the "Add WiFi Credentials" box.
3. You will then need to enter your SSID (Network name) and WiFi Password
4. Click Save
Your WiFi has now been set. This will allow your walt radio to connect to your chosen WiFi network.
To Set your APN:
1. Place your sim card in your walt radio by taking your sim pin and pressing it into the whole on the sim card slot on your radio.
2. Select the "Cellular Settings" tab at the top of your "walt Settings" screen.
3. Fill out all of the required fields as shown below.
4. Once the appropriate information has been filled out, select the blue "Save" button in the lower right-hand corner of your screen.
5. After you save your information, you will see a QR code generate under the "Configuration QR Code".
6. This will allow you to scan the QR code on your walt radio and connect to your private network.
To Change walts General Settings:
1. Admins can now set an "Update Time" for all walts on your account, defaulted to midnight. This allows for your walts to stay up-to-date, allowing the updates to happen at the least disruptive time. walts that are undocked will check for and apply updates if available. Updates will be completed in the background and the User will be prompted to restart walt after the update is complete. walts that are docked will continue to check for any updates immediately after being docked.
2. You can adjust the walt™ Lock Screen Time by clicking the blue circle and dragging it left to decrease the lock screen time and to the right to increase the lock screen time.
Pro Tip: The lock screen time is defaulted to 5 minutes (300seconds). After your walt has sat idle for 5 minutes, it will require you to put your 4-digit pin in.
To Change walts Undock Alarm Settings:
The Dock Alarm Setting is there to remind you to log into your walt once you have taken it off of the wrangler (mass charging station).
If the "Enabled" box is check marked blue (see below), then that means an alarm will sound after (x) amount of minutes.
If the box is not highlighted blue (see above), then that means the alarm has been disabled and will not sound.
1.You can adjust the walts Undock Alarm Settings by clicking the blue circle and dragging it left to decrease the dock alarm time and to the right to increase the dock alarm time.